This page was exported from Up-To-Date And Reliable MCPD Exam Questions For 100 Percent Pass [ ] Export date:Thu Jan 23 5:26:45 2020 / +0000 GMT ___________________________________________________ Title: [3/Apr/2018 Updated] Free PassLeader 300-101 Study Guide With Free VCE and PDF Download --------------------------------------------------- New Updated 300-101 Exam Questions from PassLeader 300-101 PDF dumps! Welcome to download the newest PassLeader 300-101 VCE dumps: (557 Q&As) Keywords: 300-101 exam dumps, 300-101 exam questions, 300-101 VCE dumps, 300-101 PDF dumps, 300-101 practice tests, 300-101 study guide, 300-101 braindumps, Implementing Cisco IP Routing Exam P.S. New 300-101 ROUTE dumps PDF: >> New 300-115 SWITCH dumps PDF: >> New 300-135 TSHOOT dumps PDF: NEW QUESTION 536Which three protocols support DMVPN? (Choose three.) A.    EIGRPB.    RIP2C.    OSPFD.    BGPE.    ISIS Answer: ABC NEW QUESTION 537When a packet is denied by an IPv6 traffic filter, which additional action does the device perform? A.    It scans the rest of the ACL for a permit entry matching the destination.B.    It generates a TCP Fin bit and sends it to the source.C.    A creates a null route for the destination and adds it to the route table.D.    It generates an ICMP unreachable message for the frame. Answer: A NEW QUESTION 538Which two commands must you configure in the calling router to support the PPPoE client? (Choose two.) A.    peer default ip address poolB.    bba-group pppoeC.    pppoe-client-dial-pool-numberD.    mtuE.    pppoe enable group Answer: CD NEW QUESTION 539What is the default maximum segment size for TCP traffic? A.    536B.    1492C.    1500D.    1508E.    3340F.    4096 Answer: A NEW QUESTION 540Which two statements about Frame Relay LMI autosense are true on a Router? (Choose two.) A.    It requires the LMI type to be explicitly configured.B.    It operates on Frame Relay DTE interfaces.C.    It operates on Frame Relay DCE interfaces.D.    It operates when the line is up by the line protocol is down.E.    It requires the line protocol to be up. Answer: BDExplanation: NEW QUESTION 541Which Cisco Express Forwarding table or tables hold forwarding information? A.    FIB table onlyB.    Adjacency tables onlyC.    FIB and adjacency tables onlyD.    FIB, RIB, and adjacency tables Answer: BExplanation:Cisco Express Forwarding uses adjacency tables to prepend Layer 2 addressing information to packets. NEW QUESTION 542Refer to exhibit. If the IGP in AS65000 is RIPv2, which networks are displayed when you enter show ip route on router R2?...... A.    VLSM subnts in and the major network onlyB.    VLSM subnets in and the major network onlyC.    VLSM subnets in onlyD.    Major networks and onlyE.    VLSM subnets in and the major networks Answer: D NEW QUESTION 543Which three statements about IPv6 EIGRP are true? (Choose three.) A.    EIGRP neighbor relationships are formed using the link-local address.B.    EIGRP neighbor relationships can be formed only on the configured IPv6 address.C.    It supports EUI-64 addresses only.D.    EIGRP route advertisement is configured under the interface configuration.E.    An IPv6 EIGRP router ID is required.F.    EIGRP route advertisement is configured under the ipv6 router eigrp configuration. Answer: ADE NEW QUESTION 544Which two technologies can encapsulate an IPv6 payload in an IPv4 packet for transmission across a network? (Choose two.) A.    L2TPv3B.    TrunkingC.    AToMD.    ISATAPE.    NAT-PT Answer: DE NEW QUESTION 545Which two statements about OSPF E1 routes are true? (Choose two.) A.    They are preferred over interarea routes.B.    They use the OSPF cost from redistribution and the OSPF cost to the ASBR.C.    They are preferred over E2 routes.D.    They use only the OSPF cost to the ASBR.E.    They use only the OSPF cost from redistribution. Answer: BCExplanation: NEW QUESTION 546Which command do you enter to filter only routing updates that are sent through interface GigabitEthernet0/0? A.    R1(config-if)#passive-interface GigabitEthernet0/0.B.    R1(config-router)#no passive-interface GigabitEthernet0/0C.    R1(config-router)#passive-interface GigabitEthernet0/0D.    R1(config-router)#passive-interface defaultE.    R1(config-if)#passive-interface defaultF.    R1(config-router)#distribute-list 1 GigabitEthernet0/0 out Answer: C NEW QUESTION 547...... NEW QUESTION 555Drag and DropDrag and drop the methods supported by the aaa authorization command from me left onto me correct descriptions on the right....... NEW QUESTION 556Drag and DropDrag and drop the ACL types from the left onto the correct description on the right....... NEW QUESTION 557Drag and DropDrag and Drop the Frame Relay LMI extensions from the left onto the correct descriptions on the right....... Download the newest PassLeader 300-101 dumps from now! 100% Pass Guarantee! 300-101 PDF dumps & 300-101 VCE dumps: (557 Q&As) (New Questions Are 100% Available and Wrong Answers Have Been Corrected! Free VCE simulator!) P.S. New 300-101 ROUTE dumps PDF: >> New 300-115 SWITCH dumps PDF: >> New 300-135 TSHOOT dumps PDF: --------------------------------------------------- Images: --------------------------------------------------- --------------------------------------------------- Post date: 2018-04-03 03:59:41 Post date GMT: 2018-04-03 03:59:41 Post modified date: 2018-04-03 03:59:41 Post modified date GMT: 2018-04-03 03:59:41 ____________________________________________________________________________________________ Export of Post and Page as text file has been powered by [ Universal Post Manager ] plugin from